Log Installation - kozy heat CHASKA-XL CSK-335 Installation & Operating Manual

K. LOG INSTALLATION - Log Set #CXL-500
This log set includes 11 logs and 1 pkg. rock wool burning embers.
Note: Each log is numbered on the bottom and should be installed according to the instructions and
diagrams below.
1. Install base logs, CX1, CX2, CX3, onto the burner as shown
in Figure K-1, aligning the mounting holes in the bottom of
the logs to the mounting studs in the burner.
IMPORTANT: Push the logs down onto the mounting studs
so that the logs will be setting on the burner assembly.
2. Install ember logs, CX4 & CX5 in front of the burner as
shown in Figure K-1.
3. Install top logs, CX6 - CX11 onto the base logs aligning the
logs to the corresponding notched out sections in the base
logs. Figure K-2.
4. Place rock wool burning embers as desired onto the logs
and burner to enhance glowing effect and flame
appearance.
NOTE: You will not use all the rock wool burning ember
material at this time. Save for future use.
Completed Log Set Installation
Page 16
CX1
CX2
CX4
Figure K-1
CX6
CX7
CX11
CX10
Figure K-2
CX3
CX5
CX8
CX9