Position The Insert - kozy heat CHASKA-XL CSK-335 Installation & Operating Manual

ˆ OPTIONAL: We recommend placing non-faced
fiberglass batting insulation between the pipes and
existing chimney to prevent heat loss up the chimney.
(See Figure E-4)
OPTIONAL:
PLACE NON-FACED FIBERGLASS BATTING INSULATION
BETWEEN THE PIPES AND EXISTING CHIMNEY TO
PREVENT HEAT LOSS UP THE CHIMNEY.
3. CONNECT THE VENT SYSTEM TO THE AIR DUCT
A. Place the air duct into the existing fireplace opening. Figure E-5.
B. Place a bead of sealant (provided) around the 3" exhaust pipe (red marking) and slide it inside the 3" collar marked
'Exhaust' on the air duct. Secure with (3) ½" self-tapping screws, provided. Apply additional sealant around the
joint to ensure an air tight seal. Figure E-6.
C. Apply a liberal bead of sealant (provided) around the 3" collar on the air duct. Slide the 3" combustion intake pipe
over the collar and secure with (3) ½" self-tapping screws, provided. To ensure an air-tight seal, apply additional
sealant around the joint. Figure E-6.
Figure E-5
AIR DUCT
Figure E-4
Page 11
Figure E-6