Routing; Configure Ipv4 Static Routing - D-Link DWC-1000 User Manual

Section 5 - Advanced Network Configuration
A static route tells network devices about an exact, fixed (hard-coded) destination. Static routes can work well
with small networks. There are two kinds of static routing: Static Route and Protocol-Binding. The Static Route
uses IP address to determined where is the next hop, whereas Protocol-Binding use protocol. Configuring your
wireless controller for static routing allows data transfers between it and a routing device without needing to
use dynamic routing protocols.
Path: Network > Routing > Static Routes
To add a static route:
1. Click Network > Routing > Static Routes.
2. Click Add New Static Route. The Static Route Configuration page will appear.
3. Complete the fields in the table on the next page and click Save.
D-Link DWC-1000 User Manual

routing

Configure iPv4 static routing

162