Routing Setup - D-Link DSL-2641B User Manual

Section 3 - Configuration

ROUTING SETUP

Enter the destination network address, subnet mask, gateway AND/OR available WAN interface then click "Apply" to add the entry to the routing
table.
A maximum 32 entries can be configured Allows you to configure RIP (Routing Information Protocol). To activate RIP for the device, select
the 'Enabled' radio button for Global RIP Mode. To configure an individual interface, select the desired RIP version and operation, followed by
placing a check in the 'Enabled' checkbox for the interface. Click the 'Apply' button to save the configuration, and to start or stop RIP based on the
Global RIP mode selected.
ROUTING -- STATIC ROUTE
Please click the Add or Edit button to set a static routing policy
in the list.
Please type the Destination Network Address and
Subnet Mask.
Please select to type the Gateway IP or the interface to be
the routing interface.
Click the Apply the button to save the configuration.
ROUTING -- RIP CONFIGURATION
Please choose the Version and Operation, and then decide to
Enable or not.
D-Link DSL-2641B User Manual 64