D-Link DWC-1000 User Manual page 136

Section 5 - Advanced Network Configuration
Field
Dns server source
Primary Dns server
secondary Dns server
MAC Address source
MAC Address
MtU size
Custom MtU size
Port speed
D-Link DWC-1000 User Manual
Choose one of the following options:
• Get Dynamically from ISP: Choose this option if your ISP did not assign a static DNS IP address.
• Use These DNS Servers: Choose this option if your ISP assigned a static DNS IP address for you to use.
Also complete the fields below.
Enter the primary DNS server.
Enter the secondary DNS server.
Choose Use Default Address unless your ISP requires MAC authentication and another MAC address has been
previously registered with your ISP. In that case, choose one of the following options:
• Clone your PC's MAC Address: Choose this option to assign the MAC address of the computer that you
are using to configure the controller.
• Use this MAC Address: Choose this option if your ISP assigned a MAC address for you to use. Also
complete the fields below.
Enter a MAC address in the following format: XX:XX:XX:XX:XX:XX where X is a number from 0 to 9 (inclusive) or
an alphabetical letter between A and F (inclusive).
The MTU (Maximum Transmit Unit) is the size of the largest packet that can be sent over the network. The
standard MTU value for Ethernet networks is usually 1500 Bytes and for PPPoE/PPTP connections, it is 1492
Bytes. For all l2tp connections, it is 1460 Bytes.
Enter a specific MTU size.
The Ethernet port speed can be manually set or specified depending on you Option1/Option 2 requirements.
Description
Dns servers
MAC Address
Port settings
136