D-Link DWC-1000 User Manual page 122

Section 5 - Advanced Network Configuration
Field
status
Mode
Domain name
server Preference
Dns servers
Primary Dns server
secondary Dns server
lease/rebind time
Prefix Delegation
D-Link DWC-1000 User Manual
DHCPv6
Toggle On to enable DHCPv6. It is disable in default.
If DHCPv6 is Enabled (ON)
There are two ways to obtain an appropriate address for the gateway. You must select
one of the following:
• Stateless Address Auto Configuration: This option will use router advertisement
for address assignment. The IPv6 RADVD protocol will be enabled to advertise this
controller as a DHCPv6 client.
• Stateful Address Auto Configuration: Select this option to request an IPv6
address from any available DHCPv6 servers available on the ISP.
Name of the domain (Optional) for this DHCPv6 server.
This is used by the stateless DHCP to indicate the preference level of this DHCP server.
DHCPv6 clients will pick up the DHCPv6 server which has highest preference value. The
preference value must be a decimal integer and be between 0 and 255 (inclusive).
Select one of the following options for DNS servers for the DHCPv6 clients
• Use DNS Proxy: On button to enable DNS proxy on this LAN, or Off this button to
disable this proxy. When this feature is enabled, the controller will act as a proxy for
all DNS requests and communicate with the ISP's DNS servers (as configured in the
Option settings page)
• Use DNS from ISP: This option allows the ISP to define the DNS servers (primary/
secondary) for the LAN DHCP client
• Use below: if selected, the below configured Primary and Secondary DNS servers
are used for DHCPv6 clients.
Enter the primary DNS server address.
Enter the secondary DNS server address.
Duration (in seconds) for which IP addresses will be leased to clients.
On/Off button for Enable/Disable Prefix Delegation.
Description
122