Managed - D-Link DWC-1000 User Manual

Section 8 - Viewing Status and Statistics
Path: Status > Wireless Information > Access Point > Managed
The Managed AP List page shows details about the managed access point. right clicking a managed access point
enables more options.
Field
Model name
Firmware Version
MAC Address (*) Peer Managed
iP Address
location
status
Configuration status
D-Link DWC-1000 User Manual

Managed

The model of the managed AP.
The firmware version of the managed AP.
Ethernet address of the managed access point. If an asterisk (*) follows the
MAC address, the access point is managed by a peer controller.
Network IP address of the managed access point.
An optional description of where the AP is physically located. Configured
through the AP management section.
Current managed state of the access point. Possible values are:
• Discovered = access point is discovered by the wireless controller, but not
authenticated.
• Authenticated = access point has been validated and authenticated (if
authentication is enabled), but it is not configured.
• Managed = profile configuration has been applied to the access point
and the access point is operating in managed mode.
• Failed = wireless controller lost contact with the access point. A failed
entry remains in the Managed AP database, unless you remove it. Note
that a managed access point shows a failed status temporarily during a
reset.
If management connectivity is lost for a managed access point, both of
its radios are turned down and all clients associated with the access point
are disassociated. The radios resume operation when that access point is
managed again by a wireless controller.
Shows whether the configuration profile applied to the managed access point
is successful or not.
Description
296