Spillover - D-Link DWC-1000 User Manual

Section 5 - Advanced Network Configuration
1. Click Network > Internet > Option Mode.
2. Complete the fields from the table below and click Save.
Field
option Mode
load Balance
Dns lookup Mode
retry interval is
Failover After
load tolerance
Max Bandwidth
save
D-Link DWC-1000 User Manual

spillover

Select Load Balancing from the drop-down menu.
Select Spillover Mode.
• Option DNS Servers: DNS Lookup of the DNS Servers of the primary link is used to detect primary
Option connectivity.
• DNS Servers: DNS Lookup of the custom DNS Servers can be specified to check the connectivity of
the primary link.
• Ping these IP addresses: These IP's will be pinged at regular intervals to check the connectivity of
the primary link.
• Retry Interval is: The number tells the controller how often it should run the above configured
failure detection method.
• Failover after: This sets the number of retries after which failover is initiated.
Enter the time in seconds to initiate the DNS Lookup Mode. Default is every 30 seconds.
Enter the number of failures before the controller will enable the failover process.
Enter the percentage of bandwidth after which the controller switches to the secondary Option.
This sets the maximum bandwidth tolerable by the primary Option for outbound traffic.
Click to save and activate your settings.
Description
144