Isatap Tunnels (Ipv6) - D-Link DWC-1000 User Manual

Section 5 - Advanced Network Configuration
Path: Network > IPv6 > ISATAP Tunnels
ISATAP (Intra-Site Automatic Tunnel Addressing Protocol) is an IPv6 transition mechanism meant to transmit
IPv6 packets between dual-stack nodes on top of an IPv4 network. ISATAP specifies an IPv6-IPv4 compatibility
address format as well as a means for site border router discovery. ISATAP also specifies the operation of IPv6 over
a specific link layer - that being IPv4 used as a link layer for IPv6.
To configure ISATAP Tunnels:
1. Click Network > IPv6 > ISATAP Tunnels.
2. Click Network > IPv6 > ISATAP Tunnels. Complete the fields
Field
isAtAP subnet Prefix
end Point Address
iPv4 Address
save
D-Link DWC-1000 User Manual

isAtAP tunnels (iPv6)

This is the 64-bit subnet prefix that is assigned to the logical ISATAP subnet for this intranet. This can
be obtained from your ISP or internet registry, or derived from RFC 4193.
This is the endpoint address for the tunnel that starts with this controller. The endpoint can be the
LAN interface (assuming the LAN is an IPv4 network), or a specific LAN IPv4 address.
If you selected LAN IPv4 Address, then enter the end point address.
Click Save to save your settings.
Description
172