Reverse Warning Buzzer - Club Car 2005 FE290 Maintenance Service Supplement

ELECTRICAL COMPONENTS
3. Remove the plastic washer (12) and the spring (13).
4. Remove the cam (11).
Neutral Lockout Cam Installation
1. Install the cam (11) (Figure 12-19, Page 12-18).
2. Install the spring (13) and the plastic washer (12).
3. Install the external snap ring (14) onto the shaft. Be sure the snap ring is installed in the groove on the
shaft.
4. Connect battery cables, positive (+) cable first, and tighten hardware to 12 ft-lb (16 N·m).
See Figure 10-1, Section 10, Page 10-3. Coat terminals with Battery Terminal Protector Spray (CCI P/
N 1014305) to minimize corrosion.

REVERSE WARNING BUZZER

See General Warning, Section 10, Page 10-1.
Testing the Reverse Warning Buzzer
See Test Procedure 20, Section 11, Page 11-28.
Reverse Warning Buzzer Removal
1. Disconnect the battery cables as instructed. See WARNING "To avoid unintentionally starting..." in
General Warning, Section 10, Page 10-1.
2. Remove the center dash panel. See Key Switch Removal on page 12-13.
3. Disconnect the wires from the reverse warning buzzer (2). Do not allow wires to touch (Figure 12-20,
Page 12-19).
4. Remove the mounting screws (3) securing the buzzer to the center dash.
REVERSE
BUZZER
VIEWED WITH
FRONT BODY
REMOVED
4
2
3
Figure 12-20 Reverse Buzzer
2005 FE290 Gasoline Vehicle Maintenance and Service Supplement
M-
1
2
M+
1
Reverse Warning Buzzer
Page 12-19
12
A