Forward/Reverse Shifter Cable Adjustment - Club Car 2005 FE290 Maintenance Service Supplement

16
UNITIZED TRANSAXLE
A
Forward/Reverse Shifter Cable Installation, Continued:
Figure 16-53 Forward/Reverse Cable Routing
5. Install the ball joint socket (2) on the Forward/Reverse shifter assembly ball stud (3) (Figure 16-54,
Page 16-23).
6. Attach Forward/Reverse cable at cable retainer (7).
7. Install wire tie (8) to secure wire harness to cable at the support bracket near the Forward/Reverse shifter
assembly. See following WARNING.
ý
WARNING
• If wires are removed or replaced, make sure wiring and wiring harness is properly routed and
secured. Failure to properly route and secure wiring could result in vehicle malfunction,
property damage, personal injury, or death.

FORWARD/REVERSE SHIFTER CABLE ADJUSTMENT

With the shifter lever of the unitized transaxle in the NEUTRAL position (Figure 16-54, Page 16-23), the For-
ward/Reverse handle (9) should be straight up. For minor adjustments, the nut (1) may be loosened and the
ball joint socket (2) rotated to get the proper adjustment (Figure 16-54, Page 16-23). See following CAU-
TION.
ý
CAUTION
• Be sure threads of cable are engaged in ball joint socket at least 1/4 inch (6.35 mm). If ball
joint socket comes loose from the cable, the Forward/Reverse shifter will not operate
properly.
Page 16-22 2005 FE290 Gasoline Vehicle Maintenance and Service Supplement
Forward/Reverse Shifter Cable