Fuel Gauge/Hour Meter - Club Car 2005 FE290 Maintenance Service Supplement

12
ELECTRICAL COMPONENTS
A

FUEL GAUGE/HOUR METER

See General Warning, Section 10, Page 10-1.
Testing the Fuel Gauge/Hour Meter
See Test Procedure 26 – Fuel Gauge on page 11-31 and Test Procedure 27 – Hour Meter on
page 11-32.
With the key switch in the OFF position, the fuel gauge/hour meter fields are blank. When the key switch is
turned to ON, both fields activate. The fuel gauge initially registers full for a brief moment before indicating the
actual fuel level.
The hour meter displays the number of hours of use in increments of 0.1 hour, but does not record additional
time unless the engine is running. When the hour meter is recording, the hourglass icon at the left of the field
blinks slowly.
Fuel Gauge/Hour Meter Removal
1. Disconnect the battery cables as instructed. See WARNING "To avoid unintentionally starting..." in
General Warning, Section 10, Page 10-1.
2. Remove the center dash panel. See Key Switch Removal on page 12-13.
3. Disconnect the wires from the fuel gauge/hour meter (Figure 12-22, Page 12-22). Do not allow wires to
touch.
4. Remove the two hex nuts (3) and lock washers (4) from the threaded studs on the back of the gauge.
Remove the mounting bracket (5) from the back side of the fuel gauge/hour meter (2) and remove the fuel
gauge/hour meter from the dash.
3
4
Figure 12-22 Fuel Gauge/Hour Meter Installation
Fuel Gauge/Hour Meter Installation
1. Install a new fuel gauge/hour meter into hole in dash until flange seats against dash (Figure 12-22,
Page 12-22).
Page 12-22 2005 FE290 Gasoline Vehicle Maintenance and Service Supplement
5
2
Fuel Gauge/Hour Meter