Dust Sensor Cleaning; Alarming; Alarm Function - ECOVACS Deebot D58 User Manual

Dust sensor cleaning

14. Alarm Function

Icon Cause of failure
1. There is too much
dust in dust box.
2. There is too much
dust on dust
sensor.
1. Dust box is not fixed
into host.
2. Dust box is not fixed
properly.
1. Main brush or
driving wheel is
tangled by hair or
cloth.
2. Side brush is
blocked.
Driving wheel is
suspended.
Low battery.
The dust sensor is located at the front of dust
entrance. It is able to detect the concentration of
dust so that it can choose efficient mode to work.
We suggest you to clean dust sensor once you
clean dust box to improve work efficiency.
1. Turn off power.
2. Take out dust box and clean it.
Note:
The robot will stop working under following circumstance; there
will be alarm and tip sound at the same time. What's more,
LCD will have red light flashing. Please notice the tip on LCD.
Solution
1. Clean dust box.
2. Clean dust on up-
ground height
sensor.
1. Put dust box back
into host.
2. Re-install dust box
and press it down at
the same time.
1. Clean main brush
2. Clean side brush
and put it back.
Must change it if
necessary.
Put the robot back
on the charging
block to charging.
Put the robot back
manually.
E n j o y S m a r t e r L i f e !
Instruction
In order to extend use life, robot will alarm
even though there is not much dust
after several cycles cleaning.
inside,
This function can prevent danger of child
or pet lifting the robot when it is operating.
25