Alarm Function - ECOVACS ECO D56 Instruction Manual

11. ALARM FUNCTION

Note
The robot will stop working under following circumstance; there will be alarm and tip sound at
the same time. What's more, LCD will have red light flashing. Please notice the tip on LCD.
Icon Cause of failure
1) There is too much
dust in dust box.
2) There is too much
dust on dust sensor.
1) Dust box is not fixed
into host.
2) Dust box is not fixed
properly.
1) Main brush or driving
wheel is tangled by
hair or cloth.
2) Side brush is
blocked.
Driving wheel is
suspended.
Low battery.
ENG - 110
Solution
1) Clean dust box.
2) Clean dust on
up-ground height
sensor.
1) Put dust box back
into host.
2) Re-install dust box
and press it down at
the same time.
1) Clean main brush
(refer to page strán-
ka 107)
2) Clean side brush
and put it back.
Must change it
if necessary.
Put the robot back on
charger to charge.
Put the robot back ma-
nually.
Instruction
In order to extend use
life, Robot will alarm
even though there is not
much dust inside after
several cycles cleaning.
This function can prevent
danger of child or pet
lifting the robot when it is
operating.