Set Frequency And Cancel Timing; Remote Control; Battery Placement - ECOVACS Deebot D58 User Manual

Note
When power is off, robot will not start work on appointment time .If you have already set appointment time
cleaning, please turn on the robot and keep it on standby status， even though it is not operating. Try to
make it stay at the charger and check whether it is connected.
Make sure the socket is connected to power supply. Or else, robot will fail to work on appointment time under
standby status because of running out of

Set Frequency and Cancel Timing

Tips :
No matter what kind of mode the robot operated in the last time, when the appointment time
coming, robot will work according to the Automatic mode.
If the robot is operating in Border cleaning mode, Fixed point cleaning mode, when the
appointment time coming, robot will not work until the next appointment time.
You can set appointment cleaning frequency via press
to clean on appointment time for one time.
to clean on appointment time everyday hereafter.
to cancel appointment timing, robot only works upon your manual
operation.

9. Remote Control

Battery Placement

Tips:
It applies two units of alkaline batteries (7#).
Please note the positive and negative when place the battery.
Change the battery when you notice it is in low battery and make sure you use the same kind of battery as
mixture is forbidden.
Take out the battery if you do not use remote control for long time to avoid electrolyte from leaking which
may cause failure.
Do not put the remote control in extremely hot or humid surroundings.
Do not fill any other substance into remote control, especially when you change battery.
Never expose the signal transmitter under sunshine or lighting equipment, or else it would cause failure.
The deposal of used battery should conform with local environmental legislation.
battery .
then release.
E n j o y S m a r t e r L i f e !
Press the key , the robot
will work as belowing sequence:
work for work
one time everyday
do not
work
17