Set Current Time Cleaning - ECOVACS DeeBot D56 User Manual

Set cur rent time
Tips :
Selection scope: hour is between 0 and 23, minute is
between 0-59.
Under normal circumstance, time display on LCD shows
current time.
Note:
When power is off, robot will not start work on appointment time. If you have already set appointment
timing cleaning, please turn on the robot and keep it on standby status.
Make sure the socket is connected to the power supply. Otherwise, robot will fail to work on appointment
time under standby status because of running out of battery.
Set Frequency and Cancel Timing
Tips :
Robot will turn to the automatic mode when the appointed time coming.
If the robot is working under border mode or fixed-point mode, when the appointed time coming, robot
will not operate appointment cleaning until the next time coming.
Press to adjust appointment cleaning frequency:
to clean on appointment time for one time.
to clean on appointment time everyday hereafter.
to cancel appointment timing, robot only works upon your manual
operation.
Downloaded From Vacuum-Manual.com Manuals
1. After appointment time setting, the
high light, and the number with time setting
is flashing.
mode
2. Set hour and minute via
press will increase one hour or minute,
while decrease one hour and minute for
3. Press
mode
setting.
For example:
Set current time
as 12:07 pm,time
display on LCD
should be:
Press the button
will work as belowing sequence:
E n j o y S m a r t e r L i f e !
and , each time
again, and then go to frequency
, the robot
work for work do not
one time everyday work
label
.
15