Programming An F-Code Transmission - Muratec MFX-1500E Operating Instructions Manual

Beyond the Basics

Programming an F-Code transmission

For this operation to work, two things must be true:
• You must know how the remote fax is using each F-Code box to which you're
transmitting — for example, as a security box or a relay box. Different fax manu-
facturers may use slightly different terms, but the concepts are the same.
• You must know the remote fax's
which you want to transmit.
To program an F-Code transmission into a programmable one-touch key:
1
Press / , , 1,
PROGRAM C ENTER
one-touch number available:
Select Program No.
73:No Number Stored
Note: If a programmable one-touch number other than 73 appears on the
, it means that you have already entered a number for 73.
LCD
Note: To erase a programmable one-touch key, see pages 2.54–2.55.
2
Press the key you want to program or change. Here, we've selected 75.
Select Program No.
75:No Number Stored
Note: If your previous command for this key was for an F-Code transmis-
sion and you want to keep this key programmed for an F-Code
transmission, use these instructions to make changes. But if you want
to assign this key to a completely different operation (for a delayed
transmission, for example), then you first must erase the stored com-
mand before programming the new one.
3
If you want to select a different programmable one-touch key than the one
that appears on the , press that key now.
LCD
4
Press . The now shows either:
ENTER LCD
75:Fax#/Com-Options
_
2.52
- sub-address and password for each box to
ITU T
. The shows the first empty programmable
LCD
75:Fax#/Com-Options
or
9-5558743_
5
Use the numeric keypad to enter the number exactly as your machine should
dial it, including whatever codes your phone system requires. The number can
be up to 40 characters in length:
75:Fax#/Com-Options
9-5558422_
Your display shows only 20 characters at a time. To view characters beyond
those 20, press to scroll to the left or /
Important: Do not press
ENTER
Note: To erase characters, press
To change just one number, press
/ to move it right. Press
PROGRAM
the number correctly.
6
Now, while you still can see the fax number on the
three times and then press
ENTER
Enter Sub-Address
_
7
Use the numeric keypad to enter the
you want to send the document. Here, we've entered 123456:
Enter Sub-Address
123456_
8
Press . The shows:
ENTER LCD
Enter Password
_
Note: If there isn't a password for this box, press
9
Use the numeric keypad to enter the appropriate
Here, we've entered 654321:
Enter Password
654321_
When finished, press .
ENTER
10
If you want the transmission to begin immediately every time you press the
key, press and skip to step 13.
ENTER
If you want to delay the transmission, press
to scroll to the right.
PROGRAM
.
to erase to the left.
CANCEL
to move the cursor left, or
to erase it. Then re-enter
CANCEL
, press -
LCD COM OPTIONS
. The shows:
LCD
- sub-address for the box to which
ITU T
, then skip to step 12.
ENTER
- password for the box.
ITU T
- , .
COM OPTIONS ENTER