Muratec MFX-1500E Operating Instructions Manual page 42

Getting started
5
Adjust resolution and contrast if necessary.
Press to change the resolution.
RESOLUTION
Press , then press
CONTRAST
6
Set the reduction or enlargement rate, if you want. (See "Setting of enlarge-
ment or reduction for copying," page 1.31.)
7
If you want to make only one copy of each page of the document, skip to step
10. Otherwise, proceed to step 8.
8
Use the numeric keypad to enter the desired number of copies for each page
in the document. You may choose one to 99 copies. Here, we've entered "3" to
choose a setting of three copies.
9
Press once or twice to "Toggle" (switch on or off) the sorting of
SORT COPY
copies, as desired.
10
Press to begin the copying process.
START
Note: To stop the copying before it is through, press
Note: Thanks to your machine's QuadAccess
copying doesn't keep you incommunicado while in progress: you can start a
fax or voice call and even receive a voice call during copying.
Using the Multi paper tray
When you need to use a size of paper not currently loaded in your machine's paper
cassette(s), or when you want to use a special type of paper (such as transparency
film), use the Multi paper tray.
Important: If loading transparency (OHP) film into the multi paper tray, be sure
that the sheet is designed for laser printers and not for copiers. Also,
be sure that the film does not have a paper backing and/or a leading
strip. If it does, remove the paper backing and/or strip before insert-
ing. Only film should go in, not film with any backing or strip.
1
Either insert the document in the
1.30
or to change the contrast.
.
STOP
feature (see page 2.37 for more),
®
or place it on the .
ADF FBS
2
Place a sheet of printout
paper on the Multi paper
tray. Then align the paper
guides to the sheet's edges
and insert the sheet until
it comes to a stop.
Note: Place the original
document in the
same orientation
as the paper in the
paper source
(which you'll select
in step 5, below).
• If you are going to make more than one copy, you should insert the print-
out paper only one page at a time.
• You may use letter-, legal- or half-letter sized paper. (Half-letter is 8.5
wide × 5.5 tall.)
3
Press ? repeatedly until the following display appears:
PAPER SIZE
4
Press .
ENTER
5
Then, if necessary, press
PAPER SIZE
paper you placed document on the
legal- or half-letter-sized paper.
Note: When you use transparency film, please select "OHP" mode.
You can use letter-sized transparency film.
6
If necessary, select desired resolution, contrast, reduction/enlargement rate.
(See "Setting of enlargement or reduction for copying," next page.)
7
Press to begin the copying process.
START
? again to select a same size of recording
or . You can select either letter-,
ADF FBS