Setting Security Transmission - Muratec MFX-1500E Operating Instructions Manual

If you've specified Mode 2 — the machine guides you
1
Enter the phone number as usual.
Press Start
19725550911_
2
Press . The shows:
START LCD
Enter PIN Number
_
3
Use the numeric keypad to enter the
Enter PIN Number
123456_
4
Press . Your machine dials the number.
START
Performing batch transmission while using the
Note: The following instructions presume you are familiar with how to set and use
both your machine's autodialer and its batch transmission feature. If you
need to review, see pages 2.7–2.15 for more on the autodialer and/or pages
2.20–2.23 for more on batch transmission.
If you've specified Mode 1 or Mode 2
Important: Any autodialer number you use with batch transmission must include
the . (To review how to include this information in an autodialer
PIN
number, review the Mode 1 instructions under "Autodialing while
using the mask," page 2.58.)
PIN
Before sending a batch transmission the first time, you must store the
batch box. Here's how:
1
Follow the steps for creating or modifying a batch box (pages 2.20–2.21).
The asks for the fax number (here, we're working with batch box 1):
LCD
1:Fax Number
_
2
Enter an autodialer number, or use the numeric keypad to enter the fax num-
ber, to which the batch transmission should go.
Important: If you're entering a number from the numeric keypad, enter the
fax number, followed by the * ("star") key and then the
3
Press to save the setting.
ENTER
.
PIN
mask
PIN
within its
PIN
.
PIN
Note: If you press without entering the
ENTER
indicates "No Number" on the
PIN
4
Continue with the steps for creating or modifying a batch box (pages
2.20–2.21).
Now you can perform batch transmission to this box while the

Setting security transmission

Your fax's security transmission feature provides extra assurance that your documents
go where you're sending them. When this feature is activated and your machine sends a
fax, the machine compares the last four digits of the dialed number to the other unit's
Subscriber (the phone number at the top of that unit's transmissions; see page 1.16).
ID
If these digits match, your call goes through. If they don't, your machine disconnects the
call and prints an error message telling you to check the condition of the remote unit.
Before you activate this feature, consider:
• Not all fax machine owners enter their phone numbers in their Subscriber
Indeed, some machines don't even have a Subscriber
mission activated, your machine would disconnect its calls to such machines.
• Access codes can cause confusion. — If an autodialer entry ends with a long-distance
or other access codes, activating this feature prevents calls to that fax.
Note: In the following instructions, your fax's
1
Press / , , 1, 0,
PROGRAM J ENTER
Security Tx :Off
Program/Enter
2
Press or / until the mode you want appears. In this example,
PROGRAM
we've chosen On.
Security Tx :On
Program/Enter
3
Press to save the setting.
ENTER
Beyond the Basics
, the fax machine beeps,
PIN
and then returns you to step 2.
LCD
mask is activated.
PIN
. So, with security trans-
ID
abbreviates Transmission as Tx.
LCD
. The shows the current setting:
LCD
s. —
ID
2.59