F-Code Transmission - Muratec F-360 Operating Instructions Manual

Advanced features
F-Code transmission and polling
With F-Code, your machine can send secure transmissions, perform relay broadcast
initiations and even poll from other
facturer.
You can do this two ways:
• Using the programmable one-touch key (see pages 3.41–3.42)
• Entering the - sub-address and password directly, which is what we'll
ITU T
describe here.
Note: For F-Code communication to work, three things must be true:
• The remote fax machine must support
• The remote fax must have a mailbox with an
on it
• You must know the
ITU
remote machine's mailbox

F-Code transmission

1
Insert the document.
2
Adjust the resolution and contrast if necessary.
3
If you want to toggle between real time transmission and memory transmis-
sion, press
MEMORY TRANSMIT
4
Press . . The
COMM OPTIONS
5
Select "F-Code Transmit" and press
6
Use the numeric keypad to enter the appropriate sub-address in the remote
machine.
Note: If you make a mistake, press
enter the correct number.
3.36
- -equipped machines, regardless of manu-
ITU T
- sub-addressing
ITU T
- sub-address created
ITU T
- sub-address and password (if any) for the
T
.
shows:
LCD
. The shows:
ENTER LCD
to erase the character, then
CANCEL
7
Press . The shows:
ENTER LCD
Note: If this sub-address does not have a password, skip to step 9.
8
Use the numeric keypad to enter the password.
9
Press . The shows:
ENTER LCD
10
Enter the fax number either by pressing a one-touch key, entering a speed-
dial number or dialing from the numeric keypad. Do not press
11
What you do now depends on when you want the transmission to begin.
• To have it begin now, skip to step 14.
• To delay it, go on to step 12.
12
Press . , . The
COMM OPTIONS ENTER
13
Use the numeric keypad to enter the day and time when the transmission
should begin, then press
ENTER
14
Press .
START
If in step 11 you chose an immediate transmission, your fax machine begins dialing.
If you chose a delayed command, the machine shows "Reserved" on the
ing that it has stored the command in memory and will complete it later.
START
shows:
LCD
.
LCD
.
, indicat-