Muratec MFX-1500E Operating Instructions Manual page 121

"Check Message" printouts
When there's a problem with a fax call and your machine detects an error, it pro-
duces an error printout headed by the words "Check Message." This printout lists
the following information about the transmission:
• The resulting error code
• A communications error message (see "What error messages can mean," below)
• The phone number (or , if programmed) of the fax machine with which your
TTI
machine had attempted to communicate.
What error messages can mean
The error messages on Check Message printouts can mean a variety of things.
Here's a brief summary:
Error message
Check condition of remote fax.
Repeat transmission.
Line is busy.
Check received documents.
Memory full.
Dialing number is not set.
Stopped.
Possible meanings
• Remote machine malfunctioned
• No "handshake" signals from remote fax
• Wrong phone number reached
• Poor phone line conditions
• No "handshake" signals from remote fax
• Document misfeed or miscount
• Unable to reach remote machine after
attempting specified number of redial tries
• Remote machine's line was busy
• Remote machine's line didn't answer
• Remote confirmation signal not received
from remote fax
• Poor line conditions caused a poor image
• Remote fax's memory is full
• Stored phone number failed to dial properly
• Someone pressed at the remote fax
STOP
in the middle of the "handshake"
Just in case ...
3.11