Machine Parameter Settings; Setting The Machine Parameters; Clearing The Machine Parameters - Muratec F-360 Field Engineering Manual

3.2 Machine Parameter Settings

3.2.1 Setting the Machine Parameters

These switches are used to program internal machine parameters. The primary back up battery maintains
these settings if power is lost.
1. From standby, press MENU, *, 0, 0.
2. Select the desired parameter using numeric keypad or cursor key, and then press [Enter].
Important: The bits are numbered 7 through 0 --- bit 7 is left most.
3. To navigate through the machine parameter settings:
• Press < key to move the cursor to the left.
• Press
to move the cursor to the right.
• Press the 0 (zero) or 1 on the numeric keypad to change the bit value.
• Press [Enter] to save the setting of the displayed parameter and advance to the next parameter.
(If you want to cancel the setting of the displayed parameter without saving, press [Cancel].)
• Press STOP to return the unit to standby.
Note: You can confirm the initial setting of each Machine parameter by the Machine Parameters List.
The Machine Parameters List will be printed by pressing MENU, *, 1, 0.

3.2.2 Clearing the Machine Parameters

Resets the machine parameters to factory defaults.
1. From standby, press MENU, *, 0, 0.
2. Press [Clear].
3. Press [Enter] to reset the all machine parameters to the factory defaults.
Note: If you want cancel the clearing the parameters, press [Cancel].
Note: To return to the standby mode, press STOP.
3-2