Review Commands, An Introduction - Muratec F-160 Operating Instructions Manual

To redial a fax call manually with the monitor speaker or an optional handset:
1
Make sure the document is in the feeder and that the resolution and
contrast are set.
2
Press / or lift the optional handset to get a dial tone.
MONITOR CALL
3
Press / .
REDIAL PAUSE
4
When you hear fax tones from the remote unit, press
Note: If a person answers the phone, use the optional handset to tell that
person you're sending a fax. When you hear fax tones, press
To redial a voice call manually using the optional handset:
1
Lift the optional handset to get a dial tone.
2
Press / . When the other person answers, use the optional
REDIAL PAUSE
handset to speak to that person.
Changing redial settings
It's up to you how many times the fax redials a number and how long it waits
between redials (that length of time between calls is the redial interval). To program
the redial settings:
1
Press / , , 0, 7,
PROGRAM J ENTER
Set # Of Redials
# (02-15):
2
Use the numeric keypad to enter the number of redials you want. Choose
from 2 to 15 redials. In this example, we've entered 03.
Set # Of Redials
# (02-15):
Important: Enter a leading zero when entering a quantity less than 10.
3
Press to save the setting.
ENTER
4
The now shows:
LCD
Set Redial Interval
Inter. (1-5):
.
START
.
02
03
1
5
Use the numeric keypad to enter the length you want between redial
attempts. Choose from 1 to 5 minutes. In this example, we've chosen 4.
Set Redial Interval
Inter. (1-5):
6
Press
ENTER

Review Commands, an introduction

.
START
Your fax machine can store many "jobs" in its memory. And it keeps track of each one
by assigning it a command number, like "C01."
Delayed commands, redial attempts and current fax transmissions are all stored in
your fax machine's memory and given a command number.
The Review Commands function gives you the power to check on each job (or
command) in your machine's memory. It also lets you cancel a command if you
decide not to send the document.
To cancel a command:
1
Press
REVIEW COMMANDS
The shows the first command, indicated by its command number and the
LCD
phone number it will dial. If a command is in progress, that will be the first
command the
C01:5552009
Program/Cancel
2
Press or /
3
Press
CANCEL
C01:5552009
Check Program/Cancel
4
If you want to cancel this command, press
5
The now shows the next command.
LCD
If you want to cancel it, too, go back to step 4.
If you don't want to cancel this command but do want to review other
commands, press /
back to step 4.
If you want to stop reviewing the stored commands, press
machine to standby mode.
For more information on the Review Commands function, see page 2.18.
4
to save the setting.
.
shows:
LCD
until the command you want to cancel appears.
PROGRAM
. The shows:
LCD
CANCEL
until the command you want appears. Then go
PROGRAM
Getting started
again.
to return the
STOP
1.17