Setting Up A Wlan Connection; Setting Up A Bluetooth Connection - CAB eos 4 Configuration Manual

2 Connecting Label Printer to Computer
2.4

Setting Up a WLAN Connection

To set up a WLAN connection a WLAN USB Adapter (Part No. 5906225 ) is required.
1. Connect the WLAN USB adapter to an USB master interface.
2. Start the Offline menu.
3. Select Setup > Interfaces > Network > WLAN.
4. Set DHCP or IP and Mask and if necessary Gateway for WLAN operation  "4.1.4" on page 16.
5. Select Access-Point.
6. Select Scan.
The display shows the available Access-Points.
7. Select the Access-Point to be used and confirm the selection with
8. If the network is protected a prompt to enter the passkey appears in the printer display. Enter the passkey and
select .
9. If the IP address is assigned by DHCP, identify the IP in the Short status  "5.2" on page 26.
10. Call up the printer web interface  "4.2.1" on page 18.
11. Open the "Setup" tab on the printer web interface.
12. Set the parameters described in  Tab "Setup" on page 20 in the path Setup > Interfaces > Network.
Notice!
i
For changing parameter settings user name and password must be entered  page 21.
User name : admin
Password (Default) : admin
13. Set up print service if necessary  "2.1.1" on page 6.
14. Adjust Windows printer setting  "2.1.2" on page 6.
!
Attention!
 Do not change the settings of the "IP" and "Gateway" on the printer web interface, as otherwise the
connection to the printer may be lost.
2.5

Setting Up a Bluetooth Connection

To set up a Bluetooth connection a Bluetooth USB Adapter (Part No. 5906226 ) is required.
Notice!
i
A Bluetooth software is delivered with the Bluetooth USB Adapter.
1. Connect the Bluetooth USB adapter an to an USB master interface.
2. Switch on the printer.
3. Install the Bluetooth software on the computer.
4. Start the Bluetooth software.
5. Start "Search devices".
The printer will be shown in a list of Bluetooth devices.
6. Optional : For an well-defined connection of the devices select the printer and click "Connect Devices".
Either a passkey will be shown or a window will be opened where a passkey can be set.  Set a passkey if
necessary .
The display of the printer shows a prompt to enter the passkey too.  Enter the passkey.
7. Select in the software "Connecting" via "Serial Bluetooth Interface".
The new interface, e.g COM5, will be shown
8. Install the current printer with connection via the new COM interface in the label software or in Windows.
.
7