Service Functions; Firmware Update From Storage Device; Load Settings - CAB eos 4 Configuration Manual

6

Service Functions

6.1

Firmware Update from Storage Device

Notice!
i
The firmware file can be obtained from the internet.
Access only with storage device defined as Default storage !

1. Select Setup > Interfaces > Default Storage > USB Memory  "4.1.4" on page 16.
2. Format USB flash drive in the printer  "9.5.3" on page 44.
The directories "fonts", "images", "labels" and "misc" are created on the storage device here.
3. Copy the firmware file to the "misc" directory of the storage device. This can be done on a computer or via FTP on
the printer.
4. Insert the prepared storage device into the printer.
5. Start Offline menu.
6. Select Service.
If the menu is protected via a PIN a prompt appears in the display. Enter the code number and confirm with OK.
7. Select Firmware fr. storage device.
The names of the firmware files found on the storage device are shown in the display.
8. Select the desired file an confirm with
The selected firmware file is copied. A progress indicator is displayed while the firmware is being copied. After
completion the printer will be re-started.
Notice!
i
The firmware update also can be done via FTP printer management  "8.4" on page 41.
6.2

Load Settings

Access only with storage device defined as Default storage !

A printer configuration previously saved to a storage device (USB flash drive, Internal Flash File System) can be
loaded with the Load settings function.
1. If the printer configuration was saved to an USB flash drive, select USB Memory as Default Storage and
insert USB flash drive into an USB master interface.
If the printer configuration was saved on the Internal Flash File System, select IFFS as Default Storage.
2. Start Offline menu.
3. Select Service.
If the menu is protected via a PIN a prompt appears in the display. Enter the code number and confirm with OK.
4. Select Load settings.
5. Select the desired file.
6. Confirm with
Loading of the configuration data starts. Do not remove the USB flash drive until the loading procedure is
complete. The printer returns to the Service menu.
If an error occurs during the loading procedure, an error message appears in the display. Restart the loading
procedure in this case. If an error occurs again, the configuration parameters must be entered via the control panel.
.
.
35