Settings; Setting The Winding Direction; Adjusting The Guide Axle - CAB ER4 Series Operator's Manual

4

Settings

4.1

Setting the Winding Direction

With the setting of the winding direction it is possible to rewind the labels inside or outside.
!
Attention!
Risk of gear defect!
 Switch off the device before changing the winding direction.
ER4/210
1
Figure 4 Setting the winding direction
 Select the winding direction with the switch (1):
Rewinding with labels inside
Rewinding with labels outside
4.2

Adjusting the Guide Axle

Depending on the used printer the guide axle should be adjusted so that the label strip is led horizontally from the
printer to the rewinder.
Figure 5 Adjusting the guide axle
ERx/300
1
ER4/210
1. Loosen the guide axle (1) by turning it
counterclockwise.
2. Move the axle in the guide plate (2) to the
desired position.
1
3. Fasten the guide axle (1) by turning it clockwise.
2
ERx/300
9