CAB eos 4 Configuration Manual page 12

12 4 Configuration
4.1.2 Machine Parameters
 Start Offline menu.
 Select Setup > Machine param..
Parameter
Printhead pos. X
Printhead pos. Y
Tear-off pos.
Demand sensor
> Peel position
> Backfeed delay
> Liner tension
Cutter
> Cut position
> Cutting depth
Backfeed
position
Brightn. LCD
Contrast LCD
Volume Speaker
Time Powersave
Meaning
Shifting of the entire print image perpendicular to the direction of
paper flow.
The absolute shifting is limited by the margins of the print zone.
Those are determined by the width of the printing line on the
printhead. The Printhead pos. X can also be set via software.
The offset values from the Machine param. menu and the
software are added together.
Shifting of the entire print image in the direction of paper flow. With
positive values, printing begins later in the direction of paper flow.
Shifting of the print image in the direction of paper flow also influ-
ences the cut position.
 Correct the Cut position parameters by the same value in the
opposite direction.
The Printhead pos. Y can also be set via software. The offset
values from the Machine param. menu and the software are
added together.
Shifting of the tear-off position in the direction of paper flow. With
positive values, the label strip is transported farther out of the printer.
Configuration of the peel-off parameters for devices with dispenser module.
If dispenser module is not installed, access only with service key
inserted
Offset of the peel position relative to the rear label edge.
The Peel position can also be set via software. The offset values
from the Machine param. menu and the software are added
together.
Delay time between removing the label from the peel position and
the backfeed of the label.
Setting of the peel-off tension
Access only with service key inserted
Configuration of the cut parameters for devices with cutter.
If cutter is not installed, access only with service key inserted
Offset of the cut position relative to the rear label edge.
The Cut position can also be set via software. The offset values
from the Machine param. menu and the software are added
together.
with perforation cutter only
Setting of the perforation depth.
The Cutting depth can also be set via software. The offset values
from the Machine param. menu and the software are added
together.
Offset of the backfeed movement
Brightness of the LCD display from 1 to 8.
Contrast of the LCD display from 0 to 15.
Volume of the speaker : Mute, 1 or 2.
Time between the last operation and activation of energy-saving
mode.
12
Default
0,0 mm
0,0 mm
0,0 mm
0,0 mm
250 ms
0%
0,0 mm
0
1,0 mm
8
6
1
5 min