Unpacking And Setting-Up; Connecting The Device; Connecting To The Power Supply; Connecting To A Computer Or Computer Network - CAB AXON 1 Original Instructions Manual

2 Installation
31
Figure 3 Connections
2.2

Unpacking and Setting-up

i
Note!
Please keep the original packaging.
!
Attention!
The device and printing materials will be damaged by moisture and wetness.
 Set up the device only in dry locations protected from splash water.
 Lift the labelling system out of the box.
 Check the labelling system for damage which may have occurred during transport.
 Remove foam transportation safeguards near the printhead.
 Check delivery for completeness.
Contents of delivery:
• Labelling system
• Power cable
• USB interface cable
• Instructions
 Set up the labelling system on a level surface.
2.3

Connecting the Device

2.3.1

Connecting to the Power Supply

 Check that the device is switched off.
 Plug the power cable into the power connection socket (24).
 Plug the power cable into a grounded socket.
2.3.2

Connecting to a Computer or Computer Network

!
Attention!
Inadequate or no grounding can cause malfunctions during operations.
Ensure that all computers and cables connected to the device are grounded.
 Connect the device to a computer or network by a suitable cable.
For details of the configuration of the individual interfaces 
2.4

Switching on the Device

When all connections have been made:
 Switch the device on at the power switch (25).
The device performs a system test, and then shows the system status Ready in the display (1).
24 25
30 29 28 27 26
22 Power connection jack
23 Power switch
24 Slot for SD card
25 2 USB host interfaces for keyboard,
scanner, USB memory stick, Bluetooth
adapter or service key
26 USB Hi-speed device interface
27 Ethernet 10/100 Base-T
28 Serial RS-232 port
29 Slot for I/O interface (Option) or 2 Port
Ethernet Switch (Option)
Configuration Manual cab printers
7