CAB eos 4 Configuration Manual page 15

4 Configuration
Parameter
Error-Reprint
Reprint option
Protocol error
Barcode error
Width ASCII dump
ZPL
> Printing width
> Label length
Parameters of the menu Setup > Print param.
Table 5
Meaning
On: With a correctable error and corresponding troubleshooting,
the label being printed when the error occurs is repeated.
Off: Print job is continued with the next label.
Printing of another label with the information of the previous print
job by touching . This function can be executed until the print
buffer is cleared with .
On: Printer switches to Error mode when unknown or faulty data is
received.
Off: When working with older computer operating systems, it is
possible that the print spooler of the operating system will reply to
the printer with normal status messages of the printer (e.g. end of
paper) in the form of ASCII text. The printer cannot interpret this
data and outputs a large number of protocol errors. In this case, it is
advantageous to set the Protocol error parameter to Off.
!
Attention!
If the Protocol error parameter is set to Off,
protocol errors which can be traced back to faulty
programming are also ignored. There is a risk of data
loss.
Access only with service key inserted!
On: With faulty barcode contents or size specifications, printing is
interrupted.
Off: Printing is not interrupted if an error occurs. If barcode
contents are faulty, the printer attempts to replace the incorrect data
with valid characters (e.g. zeros). If barcode size specifications are
faulty, a gray area is printed instead of the barcode.
Width of the printing area in the ASCII Dump test function
 "5.7" on page 32.
With the Automatic setting, the printout of the control sequences
arriving at the printer occurs over the maximum printing width. The
printing area width can be reduced down to 50 mm.
Setting of the label parameters for ZPL data.
Access only when at least one interface is set to operate ZPL data..
Setting the print width
Setting the label length
15
Default
On
On
On
On
Automatic
100,0 mm
150,0 mm