Unpacking And Setting-Up The Printer; Connecting The Device; Connecting To The Power Supply; Connecting To A Computer Or Computer Network - CAB MACH 4.3S/200B Operator's Manual

2 Installation
2.2

Unpacking and Setting-up the Printer

 Lift the label printer out of the box.
 Check label printer for damage which may have occurred during transport.
 Check delivery for completeness.
Contents of delivery:
• Label printer
• Power cable
• USB cable
• Operator's Manual
• DVD with label software, Windows driver and documentation
i
Note!
Please keep the original packaging in case the printer must be transported or returned.
!
Attention!
The device and printing materials will be damaged by moisture.
 Only set up label printers in dry locations protected from water and moisture.
 Set up printer on a level surface.
2.3

Connecting the Device

The standard available interfaces and connectors are shown in Figure 3.
2.3.1

Connecting to the Power Supply

The printer is equipped with a wide area power unit. The device can be operated with a supply voltage of
230 V~/50 Hz or 115 V~/60 Hz without adjustment.
1. Check that the device is switched off.
2. Plug the power cable into the power connection jack (21).
3. Plug the power cable into a grounded socket.
2.3.2

Connecting to a Computer or Computer Network

!
Attention!
Inadequate or no grounding can cause malfunctions during operations.
Ensure that all computers and cables connected to the label printer are grounded.
 Connect the label printer to a computer or network with a suitable cable.
For details on the configuration of the individual interfaces  Configuration Manual.

Switching on the Device

2.4
When all connections have been established:
 Switch the printer on at the power switch (20).
The printer performs a system test, and then shows the system status Ready in the display (7).
7