Turning Off The Server - Fujitsu Primergy RX100 S3 User Manual

1.4.3 Turning Off the Server

1
Make sure that the CD-ROM drives are empty.
2
Shut down the OS.
In the following cases, the server is turned off after the OS is shut down (Step 3 is not necessary).
• Windows OS
• When ServerView is installed
In other cases, shut down the OS and make sure that hard disk access LEDs are off.
3
Press the power switch at the front of the server.
The server's power LED turns amber.
4
Turn off the display and peripheral devices.
The time to turn off the server can be set with the ASR setting (on the [Power On/Off] tab) using
ServerView supplied with this server. For details, refer to "3.2 Settings for Server Monitoring" in
"ServerView User's Guide" on the PRIMERGY Document & Tool CD.
If you press the [F8] key right after the POST memory amount check, the Boot Menu is displayed,
where you can change the boot disk ( "
• In the event of smoke or sparks, immediately unplug the power plug from the
outlet. Failure to do so may lead to a fire or electric shock.
• When turning off the server, be sure to follow the procedures described in this
section. Data may be lost if these procedures are not followed correctly.
The server's
Power switch
power LED
turns amber
• Be sure to wait for 10 seconds or longer after shutdown before turning the
server on.
■
How to Start the BIOS Setup Utility" (pg.202)).
PRIMERGY RX100 S3 User's Guide
1
33