Fujitsu Primergy RX100 S3 User Manual page 140

Chapter 5 Operations after OS Installation
• Included information
Common header, minidump header, kernel module, memory information, processor information,
process information, thread information, stack page, unloaded module information
• Required size
2MB or more
■ Memory Dump File Setting
Set up the memory dump file according to the following procedures:
1
Log on to the server with administrator privileges.
2
Check free space of the drive where the memory dump file is to be stored.
Check the required amount of free space according to "
( pg.139).
If the drive has no free space, refer to "
3
Click [Start] → [Settings] → [Control Panel].
4
Double-click the [System] icon.
The [System Properties] window appears.
5
Click the [Advanced] tab and click [Startup and Recovery].
The [Startup and Recovery] window appears.
6
Set as follows:
1. In the [Write debugging information] section, select the memory dump file type.
• Complete memory dump (Recommended)
The whole system memory information is recorded to the memory dump file.
• Kernel memory dump
Only kernel memory is recorded to the memory dump file.
• Small memory dump (2MB or more)
140
■
Checking Hard Disk Free Space"
■
Cannot Collect the Memory Dump" ( pg.250).