Installing Windows Server 2003 - Fujitsu Primergy RX100 S3 User Manual

Chapter 4 Manual OS Installation
●
Before Starting Operation
After OS installation, refer to "Chapter 5 Operations after OS Installation" ( pg.133) and perform the
necessary procedures.
■ For Onboard SCSI Configuration
When the array is not configured, and OS is installed in the hard disk drive connected with an onboard
SCSI controller, modify the registry for the onboard SCSI controller before starting operation.
If operation begins without this setting, the error on PCI bus may occur when Windows shuts down.
1
Log on with administrator privileges.
2
Insert the ServerStart Disc 1 CD-ROM.
3
Click [Start] → [Run...], enter a file name as follows and click [OK].
[CD-ROM drive] :\Programs\SCSICONF\setreg.bat
When the registry settings are completed, the following message appears.
Registry setting for SCSI Array controller / SCSI
controller was done.
Press any key to continue . . .
4
Press the [Enter] key.
The message window closes.
The new registry settings are enabled after restarting the system.

4.2.2 Installing Windows Server 2003

For details on the OS settings, refer to the following URL.
http://www.microsoft.com/technet/prodtechnol/exchange/2003/Library/default.mspx
1
Create driver disks.
Prepare necessary drivers before installing Windows Server 2003.
Some drivers are created from the ServerStart CD-ROM.
For how to create driver disks, refer to "4.1 Creating Driver Disks" ( pg.110).
118