Chapter 2 Checking Before Os Installation; Preparation On The Server; Installing Internal Options - Fujitsu Primergy RX100 S3 User Manual

Chapter 2 Checking before OS Installation

2.1 Preparation on the Server

Before starting installation, install internal options to the server and perform
necessary hardware settings.

2.1.1 Installing Internal Options

Internal options are classified into those that must be installed before the OS installation and those that
must be installed after the OS installation.
For installation procedures, refer to "Chapter 7 Installing Internal Options" ( pg.175).
●
Options That Must be Installed before the OS Installation
• Memory modules
• Expansion cards
• USB floppy disk drive
ServerStart floppy disk or driver disk is used to install the OS. Connect the USB floppy disk drive in
advance.
●
Options That Must be Installed after the OS Installation
• Optional SCSI devices
• Internal hard disk units where the OS is not installed
If an internal option device that must be installed after the OS installation has been already installed,
remove the device, install the OS, then reinstall the device.
■ Installing Optional External Devices
When installing USB devices, turn off their power or unplug their connection cables from the server
during the OS installation. Connect them after the OS installation.
■ Cautions for Installing an Expansion Card
When using an expansion card, read the notes on the expansion card.
40