Cautions For Pg-185X/186X/188X/189X Lan Driver V10.1; Teaming Function - Fujitsu Primergy RX100 S3 User Manual

Chapter 5 Operations after OS Installation
7
Click [Close].
5.7.2 Cautions for PG-185x/186x/188x/189x LAN Driver
V10.1
■ Event Log
Once a Team is setup, multiple identical logs from the same source that starts with the following log may
be stored in the system log file of the event viewer at system start-up.
Source
ID
Type
Description
Since such event logs will be stored even if the Teaming function is operated normally, ignore them.

5.7.3 Teaming Function

■ Notes
When using the Teaming function, note the following points.
• Service Pack 2 is required for Windows 2000 Server.
• For AFT/ALB/Static link type, you can incorporate up to four LAN ports into one team and two ports
for a SFT type team.
• Once a Team is created, virtual adapters (Team:(Team Name)) will be created in the [Device
Manager] and/or [Network and Dial-up Connections] of the system. Do not disable or delete this
virtual adapter from the [Device Manager] or [Network and Dial-up Connections]. When deleting a
virtual adapter, make sure to use "Intel
• When the Teaming function is being used, you can only use the following protocols:
• For AFT/SFT/Static link type: IP, NetBEUI, IPX (NCP), IPX (NetBIOS)
• For ALB type: IP, IPX (NCP)
• When the Teaming function is being used, you cannot use the hardware assist function of IPSEC. Do
not use this function even if the function is installed in all cards in the team.
• When the Teaming function is being used, you cannot use Windows Load Balancing Service
(WLBS) and Network Load Balancing (NLB).
• If Static link type is selected, you can only use the switch for link aggregation.
• When adding/deleting a Static link type member, perform such operation under a linked down state.
• Team cannot be configured on PG-1852.
• When using the onboard LAN to control remotely with RemoteControlService, it cannot be a
member of the Team. For details on RemoteControlService, refer to "ServerView User's Guide".
166
iANSMiniport
11
Warning
The following adapter link is not connected: (adapter name)
* (adapter name) varies depending on the OS or hardware configuration.
®
PROSet".