Inserting And Ejecting A Cd-Rom (Dvd-Rom) - Fujitsu Primergy RX100 S3 User Manual

Chapter 1 Overview
■ Cautions for Turning the Power On/Off (for a Windows OS)
For the server power switch, you can specify the following operation modes depending by OS settings.
• For Windows Server 2003, Windows Server 2003 x64
"Do Nothing", "Prompt Input", "Standby", "Hibernation", or "Shutdown" (normally, "Shutdown" is
specified).
• For Windows 2000 Server
"Standby", "Hibernation", "Power Off" (Normally "Power Off")
On this server, functions corresponding to "Standby" and "Hibernation" are supported as BIOS and
hardware functions. However, some drivers and software installed in the server do not support these
functions. For this reason, functions corresponding to "Standby" and "Hibernation" are unavailable on
this server.
When the operating mode is set to "Standby" or "Hibernation", the system may operate improperly or
hard disk data may be corrupted.
For details about operating mode settings, refer to the manual supplied with the OS.

1.4.4 Inserting and Ejecting a CD-ROM (DVD-ROM)

CD-ROM drive and DVD-ROM drive are available as options for this server.
Unless otherwise noted, a CD-ROM drive also means a DVD-ROM drive.
When using CD-ROMs, note the following points to avoid failures.
For DVD-ROM drive, refer to the manual supplied with the internal DVD-ROM drive unit.
■ Cautions for Handling CD-ROM Drive
• Use the drive in a dry place with low airborne dust levels. Entry of water, a paper clip, or other liquids
or metal objects can cause electric shock or failures.
• Do not use the drive in a place exposed to shocks or vibration.
• Do not insert any object other than the specified CD-ROMs.
• Do not pull or push the CD-ROM tray forcibly.
• Do not disassemble the CD-ROM drive.
• Clean the CD-ROM tray before use. Use a dry, soft cloth for cleaning.
• When the CD-ROM drive is not used for a prolonged period, eject the CD-ROM to prevent accidents.
To avoid dust or particles, keep the CD-ROM tray closed (in a loaded position).
• This server supports CD-ROMs with the following logo. Do not use CD-ROMs without the logo.
Doing so may cause failures.
34