Power On/Off Submenu - Fujitsu Primergy RX100 S3 User Manual

Item
Enhanced SpeedStep
CPU MC Status Clear
Discard Timer Mode
SMART Device Monitoring

8.1.9 Power On/Off Submenu

This submenu appears when selecting "Power On/Off" from the advanced menu.
Use this submenu to configure power On/Off settings.
Main Advanced
Power-on Source
Remote:
LAN:
Wake up Timer:
Power-off Source
Software:
Power Button:
Power Failure Recovery:
F1 Help
Exit
Esc
Item
Power-On Source
Remote
LAN
Wake Up Timer
table: Items on the Advanced System Configuration Submenu
Setting
• Disabled (Initial value)
• Enabled
Next Boot
(Unchangeable)
1024 clocks
(Unchangeable)
Enabled (Unchangeable)
Security Server
Power On/Off
[Bios Controlled]
[Disabled]
[Enabled]
[Disabled]
[Enabled]
[Enabled]
[Previous State]
-/+ Change Values
Select Item
Select Menu Enter Select
table: Items on the Power On/Off Submenu
Setting
BIOS Controlled
(Unchangeable)
• Disabled (Initial value)
• Enabled
• Disabled
• Enabled (Initial value)
Disabled (Unchangeable)
PRIMERGY RX100 S3 User's Guide
Description
Configures the CPU internal setting.
This item is displayed only when Intel
processor is installed.
Configures the CPU internal setting.
Configures the delayed transfer of PCI bus burst
transfer.
Sets whether or not to monitor SMART device.
Exit
Item Specific Help
Configure serial port
using options:
[Disabled]
No configuration
[Enabled]
User configuration
[Auto]
BIOS or OS chooses
configuration
Setup Defaults
F9
Sub-Menu F7 Previous Values
Description
Configures the power-on setting.
Sets whether or not the power is turned on
when the modem (connected to the serial
port) receives a ring signal.
Sets whether or not to enable the power to be
turned on via LAN.
Sets whether or not the power is turned on at
a certain time or after a certain time has
passed. A separate program is necessary for
setting startup time.
® ®
Pentium 4
8
213