1200V-Series Modero Connectors; Cleaning The Touch Overlay; Connecting And Using Input Devices - AMX Modero NXT-1200V Operation/Reference Manual

Introduction

1200V-Series Modero Connectors

FIG. 2 shows the connectors on the 1200V Modero Video panels. The Audio/Video RJ-45 connector provides
differential audio/video signals between the touch panel and the NXA-AVB/ETHERNET.
This connector routes Composite video, Stereo (left/right) audio, and microphone audio.
Audio-Video from
NXA-AVB/ETHERNET
(CAT5)
FIG. 2 Connector layout on sample 1200V Video Touch Panels

Cleaning the Touch Overlay

You should clean the touch screen overlay after each day's use. Always use clean cotton cloths and a spray
bottle containing water.

Connecting and Using Input Devices

The 1200V panel can have up to two USB-capable input devices connected for use on its different firmware
and TPD4 panel pages. These input devices can consist of a keyboard or mouse.
USB-connected input devices are not detected and recognized by the panel until
power is cycled to the unit.
A mini-USB connection is only detected after it is installed onto an active
panel. Connection to a previously powered panel, allows the PC to detect the
panel and assign an appropriate USB driver.
1.
Insert the input device USB connectors into the appropriate USB connector on the panel.
2.
Press the on-screen Reboot button from the Protected Setup page to save any changes and restart the
panel.
3.
After the panel splash-screen disappears:


4
NXT-1200V - connectors located
on rear panel of the base
A L
AUDIO/VIDEO ETHERNET
Power
Ethernet
(CAT5)
If a USB mouse has been connected, a mouse cursor appears on the panel screen and its location
corresponds to the mouse cursor position sent by the external USB mouse.
If a USB keyboard has been connected, only on-screen keyboards and keypads will reflect any
external keystrokes sent from the external USB keyboard.
NXD-1200V - connectors located
12VDC
PWR
Stereo
Keyboard/Mouse
Output
USB connectors (2)
NXD/T-1200V 12" Modero® Video Wall/Flush Mount Touch Panel
on left side panel
PROGRAM
Mini-USB
(Program Port)