Introduction
Connecting and Using USB Input Devices
These panels can have up to two USB-capable input devices connected for use both on its different firmware
and TPD4 panel pages. These input devices can consist of a keyboard or mouse.
USB-connected input devices are detected and recognized by the panel upon
connection. Refer to the Configuring and Using USB with a Virtual
Master section on page 87 for more information on using a USB connection.
1.
Insert the input device USB connectors into the appropriate USB connector on the panel.
2.
Press the on-screen Reboot button (Protected Setup page) to save any changes and restart the panel.
3.
After the panel splash-screen disappears:
Cleaning the Touch Overlay
You should clean the touch screen overlay after each day's use.
Always use clean cotton cloths and a spray bottle containing water.
12
If a USB mouse has been connected, a mouse cursor appears on the panel screen and its location
corresponds to the mouse cursor position sent by the external USB mouse.
If a USB keyboard has been connected, only on-screen keyboards and keypads will reflect any
external keystrokes sent from the external USB keyboard.
VG-Series Modero Touch Panels