AMX NXD-500i Operation/Reference Manual page 54

Setup Pages and Descriptions
Setup Page
Exit:
Wired icon:
Connection Status icon: This visual display of the connection status allows the user to have a current update of the
Connection Status:
Display Timeout:
Inactivity Page Flip
Time:
Panel Brightness:
42
Returns to the Main touch panel page. In this case, the previous page is the default Main page.
The icon to the left of the Connection Status Icon displays that the current connection to the
Master is Wired (image of three networked computers).
panel's connection status regardless of what page is currently active.
• A Lock only appears on the icon if the panel has established a connection with a currently
secured target Master (requiring a username and password).
Displays whether the panel is communicating externally, the encryption status of the
communicating Master, what connection type is being used (Ethernet or USB), and of what
System the panel is a part.
This visual display of the connection status is also reflected at the upper-right of each firmware
page. This allows the user to have a current visual update of the panel's connection status
regardless of what page is currently active.
• When a connection is established, the message displayed is either: "Connected via Ethernet
" or "Connected via USB ".
• If no connection can be established by the Modero panel, it will continue to try and establish
a connection while displaying: "Attempting via...".
• The word "Encrypted" appears only when an encrypted connection is established with a
target Master.
• The panel must be rebooted before incorporating any panel communication changes and
detecting any active Ethernet connections.
The Ethernet connection is only detected after the panel is rebooted.
Sets the length of time the panel can remain idle before activating the sleep mode. When the
device goes into sleep mode, the LCD is powered down.
• Press the UP/DN buttons to increase/decrease the time until the panel times out. Range = 0
- 240 minutes.
• Use this button to set the timeout value to zero and disable the sleep mode.
Sets the number of minutes of inactivity before the panel automatically flips to a
pre-selected touch panel page. When the device goes into this inactivity mode, the LCD does
not power down.
• Press the UP/DN buttons to increase/decrease the time the panel can remain inactive before
it flips to the preset page. Range = 0 - 240 minutes.
• Use this button to set the timeout value to zero and disable the inactivity page flip mode.
• The touch panel page used for the Inactivity page flip is shown within a small Inactivity Page
field.
Sets the display brightness level of the panel.
• Press the UP/DN buttons to adjust the brightness level. Range = 0 - 100.
• The on-screen bargraph can be dragged to adjust the Brightness level which is then reflected
as a corresponding numeric value within the Panel Brightness field.
• The Auto Brightness button, when selected, will cause the panel to dim as the light level
decreases, in order to reflect the brightness level of the room. If the panel is touched, the
backlight will temporarily brighten the panel more than the previously selected level.
NXD-500i 5" Modero Wall/Flush Mount Touch Panel with Intercom