NXD-500i 5" Modero Wall/Flush Mount Touch Panel with Intercom
Front Bezel Button
The NXD-500i has only one button on the front of the device, in the center of the button trim ring. This button has
several uses:
Side Panel Connectors
FIG. 2 shows the connectors located on the NXD-500i Modero panel.
Back box
FIG. 2
NXD-500i Wall/Flush Mount Touch Panel - side panel connectors
Ethernet Port
The NXD-500i has no power input port. Instead, all power is supplied via the Power over Ethernet (PoE) protocol. With
PoE, the power is supplied directly through the Ethernet port through the PS-POE-AF PoE Injector, available from
AMX.
For more information on the PS-POE-AF POE Injector, please refer to the NXD-500i Touch Panel Accessories on
page 15.
Mini-USB Port
The mini-USB port is used solely for software upload and audio output. The mini-USB port automatically detects the
presence of a headphone adaptor, allowing the port to be used for headphone connectivity.
For more information on software upgrading, please refer to the Upgrading the Firmware via the USB port on page 37.
4
Press the button once to start a previously programmed function, or to turn off the display if not previously
programmed.
Press and hold the button for 6 seconds to put the device into Setup Mode (please see the Setup Page section
on page 41 for more information).
Press and hold the button for 9 seconds to enter Calibration Mode (please see the Panel Calibration section
on page 19 for more information).
Press and hold the button for 20 seconds to reboot the panel.
Ethernet 10/100 port
Mini-USB port
NXD-500i 5" Modero Wall/Flush Mount Touch Panel with Intercom