11.
Install the two Plastite screws attaching the NXD-500i to the back box (FIG. 5).
12.
Place the Faceplate/Trim Ring assembly (A in FIG. 8) back onto the main NXD-500i unit (B in FIG. 8).
Make sure to align the Microphone, Light, and PIR Motion sensor locations to their
respective openings on the front faceplate/bezel.
13.
Reconnect the terminal Ethernet and USB to their respective locations on the Ethernet port and NetLinx Master.
NXD-500i 5" Modero Wall/Flush Mount Touch Panel with Intercom
Installation
11