AMX NXD-500i Operation/Reference Manual page 52

Upgrading Modero Firmware
6.
From within Studio, select Tools > Firmware Transfers > Send to NetLinx Device from the Main menu to open
the Send to NetLinx Device dialog (B in FIG. 37).
Verify the panel's System and Device number values match those values listed within the System folder in the
OnLine Tree tab of the Workspace window (A in FIG. 37).
FIG. 37 Using USB for a Virtual Master transfer
7.
Select the panel's Kit file from the Files section.
8.
Enter the Device value associated with the panel and the System number associated with the Master listed in the
OnLine Tree tab of the Workspace window.
The Port field is disabled.
9.
Click the Reboot Device checkbox.


10.
Click Send to begin the transfer. The file transfer progress is indicated on the bottom-right of the dialog (B in
FIG. 37).
11.
As the panel is rebooting, temporarily unplug the USB connector on the panel until the panel has completely
restarted.
12.
Once the first panel page has been displayed, reconnect the USB connector to the panel.
13.
Right-click the associated System number and select Refresh System.
This causes a refresh of all project systems, establishes a new connection to the Master, and populates the System
list with devices on your particular system.
14.
Confirm that the panel has been properly updated to the correct firmware version.
40
A
This causes the touch panel to reboot after the firmware update process is complete.
The reboot of the panel can take up 30 seconds after the firmware process has finished.
B
NXD-500i 5" Modero Wall/Flush Mount Touch Panel with Intercom