Bowers & Wilkins Zeppelin Owner's Manual page 9

9 USING THE REMOTE CONTROL
Button Action Effect
Press once Zeppelin turns on and
when Zeppelin selects last used source
in standby See also section 8.
Press once Zeppelin goes to
standby.
when Zeppelin
on A docked iPod is
paused and turned off.
Press once Volume level increases
by small increment.
Press and Volume ramps up and
hold LED flashes.
+
White LED indicates
getting near to maximum
volume.
Red LED indicates
maximum level.
Press once Volume level decreases
by small increment.
Press and Volume ramps down
–
hold and LED flashes.
Red LED indicates
minimum level.
Press once Toggle play/pause
(iPod is source).
Toggle mute on/off
(AUX is source).
6
Button Action Effect
Press once Advance to start of next
track (iPod only).
Press and Scan forward through
hold current track (iPod only).
Press once Go to start of current
track (iPod only).
Press twice Go to start of previous
track (iPod only).
Scan backwards through
Press and
hold current track (iPod only).
Press once Toggle between iPod
and AUX.
If AUX selected, iPod
will pause.
If iPod selected, it will play.
If no alternate source
connected, a red LED
indicates invalid
command.
10 USING THE CONTROLS ON ZEPPELIN
Button Action Effect
Press once Zeppelin turns on and
when Zeppelin selects last used source
in standby See also section 5.
Press once Zeppelin goes to
standby.
when Zeppelin
on A docked iPod is paused
and turned off.
Press and Toggle between iPod
hold for two and AUX.
If no alternate source
seconds when
Zeppelin on connected, a red
LED indicates invalid
command.
Press once Volume level increases
by small increment.
Press and Volume ramps up and
hold LED flashes.
+
White LED indicates
getting near to maximum
volume.
Red LED indicates
maximum level.
Press once Volume level decreases
by small increment.
– Press and Volume ramps down and
hold LED flashes.
Red LED indicates
minimum level.