Replacing Booklet Staple Cartridge (For Finisher-C1 With Booklet Maker) - Fuji Xerox ApeosPort-IV 5070 Administrator's Manual

3 Maintenance
3
Hold the tabs on both sides of a new staple
cartridge, and insert it into the original
position until it clicks.
4
Repeat steps 2 and 3 to replace the other staple cartridge.
5
Close the finisher side cover.
Note

Replacing Booklet Staple Cartridge (for Finisher-C1 with Booklet Maker)

3
When the Finisher-C1 with Booklet Maker (optional) is installed and the booklet staple
cartridge needs to be replaced, a message appears on the touch screen. When this
message appears, load a new staple case into the booklet staple cartridge.
Important • The use of staple cartridges not recommended by Fuji Xerox may degrade quality and
Note
1
Make sure that the machine is not operating,
and open the finisher front door.
2
While pressing the handle [R2] and handle
[R3] to the right (1), pull the booklet staple
cartridge unit out of the finisher (2).
3
Hold the tabs on both sides of a new booklet
staple cartridge.
70
• If the finisher side cover is not completely closed, a message will appear and the machine
will remain paused.
performance. Use only booklet staple cartridges recommended by Fuji Xerox.
• To order a booklet staple cartridge, contact our Customer Support Center.
R3
R2