Interface Cables; Using The Usb Interface; Using The Parallel Interface - Fuji Xerox ApeosPort-IV 5070 Administrator's Manual

Interface Cables

When connecting the machine directly to a computer, use either the USB interface or
parallel interface. When connecting the machine to a network, use the Ethernet
interface.

Using the USB Interface

The USB interface of the machine supports USB 2.0.
This section describes the installation procedures for the USB interface.
1
Press the power switch to the [
2
Make sure that the touch screen is blank and the <Energy Saver> button does not
light up.
3
Open the front cover.
4
Press the main power switch to the [
5
Connect a USB cable to the USB 2.0
interface connector.
6
Connect the other end of the USB cable to the computer.
7
Press the main power switch to the [ | ] position to switch on the main power.
8
Close the front cover.
9
Press the power switch to the [ | ] position to switch on the power.
10
Restart the computer.
For more information on setting items, refer to "Printer Environment Settings" (P.277).

Using the Parallel Interface

This section describes the installation procedure for the parallel interface.
Note • The parallel interface is not supported for some models. An optional component is required.
1
Press the power switch to the [
2
Make sure that the touch screen is blank and the <Energy Saver> button does not
light up.
3
Open the front cover.
4
Press the main power switch to the [
] position to switch off the power.
] position to switch off the main power.
] position to switch off the power.
] position to switch off the main power.

Interface Cables

1
21