Protocol Settings - Fuji Xerox ApeosPort-IV 5070 Administrator's Manual

Hide thumbs Also See for ApeosPort-IV 5070:
Table of Contents

Advertisement

Note
• You cannot select [Port Number] and [Operation Time-Out], if WebDAV port is disabled.
Port Number
Enter a port number for WebDAV from 1 to 65535.
The default value is 80.
Important • Do not use a number that is the same as a port number of another port. However, you can
Operation Time-Out
You can enter an operation time-out period between 1 and 65535 seconds in 1 second
increments.
ThinPrint
Port Status
You can use the machine for print in the ThinPrint.print environment. The machine
decompresses and prints the compressed print data sent from the print server.
Select [Enabled] when you use ThinPrint.
Port Number
Enter a port number for ThinPrint from 1 to 65535.
The default value is 4000.
Important • Do not use any numbers assigned to the other ports.
Note
• ThinPrint is available when the communication protocol uses IPv4.
• The maximum of three connections are possible at a time.

Protocol Settings

Set the parameters required for communications. In [Protocol Settings], you can set the
following items.
Ethernet Rated Speed
Set the communication speed for the Ethernet interface.
Auto
Select this to detect the Ethernet transmission rate automatically.
100 Mbps Full-Duplex
Select this to set 100BASE-TX (Full Duplex) as the default value.
100 Mbps Half-Duplex
Select this to set 100BASE-TX (Half Duplex) as the default value.
10 Mbps Full-Duplex
Select this to set 10BASE-T (Full Duplex) as the default value.
10 Mbps Half-Duplex
Select this to set 10BASE-T (Half Duplex) as the default value.
1000 Mbps
Select this to set 1000BASE-T as the default value.
Note
• 1000BASE-T is not available for some models. An optional component is required.
TCP/IP - IP Mode
Allows you to select the TCP/IP operation mode.
IPv4 Mode
Select this option for IPv4.
To configure [Port Number] and [Operation Time-Out], enable port status and reboot the
machine, and then configure [Port Number] and [Operation Time-Out].
use the same port number for a port that uses HTTP (IPP, Internet Services (HTTP), UPnP
Discovery, SOAP, WebDAV, and Web Services on Devices (WSD)).
Connectivity & Network Setup
169
5

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents