Outgoing/Incoming E-Mail Settings - Fuji Xerox ApeosPort-IV 5070 Administrator's Manual

5 Tools
Prioritize T.38 IP Packets
Set the priority of IP packet transmission from 0 to 255.
Note

Outgoing/Incoming E-mail Settings

Set e-mail transmission and reception settings.
POP3 Server Settings
Set the POP3 server. In [POP3 Server Settings], you can set the following items:
Note
Server Name/IP Address
Enter a server name or IP address with up to 128 characters, and then select [Save].
5
Port Number
Enter a port number from 1 to 65535.
The default value is 110.
Important • Do not use the numbers assigned to the other ports.
Polling Interval
Set the interval for checking the e-mail on the POP3 server from 1 to 120 minutes in 1 minute
increments.
Login Name
Enter the name to login to the POP3 server with up to 64 characters.
Password
Enter a password for the POP3 server with up to 64 characters.
Enter the same password in [New Password] and [Retype Password] using the numeric
keypad displayed by selecting [Keyboard]. If you do not set the password, leave the text
boxes blank and select [Save].
POP Password Encryption
Select [On (APOP)] to encrypt the password.
SMTP Server Settings
Set the SMTP server. In [SMTP Server Settings], you can set the following items:
Note
SMTP Server Name/IP Address
Enter a server name or IP address, and then select [Save]. Up to 128 characters are allowed.
SMTP Server Port Number
Enter a port number in the range from 1 to 65535.
The default value is 25.
Important • Do not use the numbers assigned to the other ports.
178
• The value set varies depending on your environment. Consult your network administrator.
• Set the value already specified by the network side. If you set other values, the priority does
not change.
(For most of Cisco routers, speech traffic is set to 184(ef). If you change the value, consult
your network administrator.)
• For IPv4, enter the address in the format "xxx.xxx.xxx.xxx", where "xxx" is a numeric value
from 0 to 255.
• For IPv6, enter the address in the format "xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx", where
"xxxx" is a hexadecimal value.
• When you make an entry mistake, press the <C> (Clear) button and enter again.
• For IPv4, enter the address in the format "xxx.xxx.xxx.xxx", where "xxx" is a numeric value
from 0 to 255.
• For IPv6, enter the address in the format "xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx", where
"xxxx" is a hexadecimal value.
• When you make an entry mistake, press the <C> (Clear) button and enter again.