Yamaha 2002 TDM900 Service Manual page 85

L Route the rear turn signal lead (left) through the left
side hole of fender.
M Route the rear turn signal light leads (right and left)
between the ribs of rear fender.
N Route the seat lock cable through the hole section
of the seat bracket of rear frame. Either direction of
the seat lock cable is acceptable.
O House the alarm coupler between the ribs of rear
fender.
P Wire the battery positive lead together with the
starter relay lead as shown in the illustration.
Q Pass the battery negative lead above the battery.
R To the fuel pump
S Fasten the wire harness to the inner side of frame
with the clamp.
A A
T Pass the wire harness, cylinder identification sensor
U Pass the wire harness, cylinder identification sen-
V To the radiator fan motor
W Bundle the coolant temperature sensor and AI sys-
X To the headlight
Y Bind the wire harness (Main switch lead), right han-
B
B
C
C
2-43
CABLE ROUTING
and radiator fan motor leads under the bracket 1.
sor and radiator fan motor leads above the hose 1.
tem leads with a clamp. Cut the clamp tip with 3 to 8
mm left.
dle bar switch lead and left handle bar switch lead
with the clamp. Point the tip of the clamp to the front
and place it between the cover and the harness.
Position the clamp at the closer point than the cou-
pler to the right side of the vehicle body as shown in
the illustration.
A A
SPEC
C C
B B