Yamaha 2002 TDM900 Service Manual page 267

CAMSHAFT
10. Turn:
S crankshaft
(several full turns counterclockwise)
11. Check:
S "T" mark a
Make sure the "T" mark on the generator ro-
tor is aligned with the stationary pointer b on
the generator rotor cover.
S camshaft punch mark c
Make sure the punch marks on the cam-
shafts are aligned with the embossed marks
d on the camshaft cap.
Out of alignment ! Adjust.
Refer to the installation steps above.
12. Tighten:
S camshaft sprocket bolts 1
CAUTION:
Be sure to tighten the camshaft sprocket
bolts to the specified torque to avoid the
possibility of the bolts coming loose and
damaging the engine.
13. Measure:
S valve clearance
Out of specification ! Adjust.
Refer to "ADJUSTING THE VALVE CLEAR-
ANCE" in chapter 3.
5-18
ENG
24 Nm (2.4 mSkg)